Hello everyone,
I need to update and configure multiple Cisco 800 modem/routers (thousands of them) so I'm looking for a solution to make it easier and faster by automating the job.
The idea is using a terminal server coupled with the CatTools software.
After lots of tests I managed to work it out except for one thing. This is the problem :
--> When the routers (Cisco 887VA) are starting for the first time they show this message before the prompt :
"
% Please answer 'yes' or 'no'.
Would you like to enter the initial configuration dialog? [yes/no]:
"
The CatTools v3.1.1 software seems unable to recognize this message as a "pre- Command Prompt question" and just reply that error message :
"Did not receive VTY entry prompt from Ciscorouter after CR "
and obviously it is not able to send any commands to the routers.
I have already tried to set up the "Variations > Pre-Login and Post-Login" but that didn't solve the problem.
In advance, thank you for you help.
Julien